The throttle connects to channel (3)

The auxiliary connects to AUX1 channel (7)

Endpoint setup [EPA]

Setup the throttle servo and linkage as close to +/- 100% EPA as possible..

Select channel 7 (AUX1) and set the [EPA] to +100% and -100%

The system is now ready for calibration. Calibration Procedure

For ThrottleMax Calibration, exit at High Stick(Yellow LED)for Limiter mode and Low stick for governor mode(Green LED)

The target rotor speed can be calculated using the EPA Calculator

Example 1): 2 position switch, single speed.

Select Channel 7

Select the Endpoint Adjust Menu [EPA]

With the switch in the up position, set the EPA to 74% (1500rpm @ 9.3:1).

With the switch in the down position, set the EPA to 0%

AUX1 Switch        Rotor RPM

Down                    Disabled

Up                        1500rpm

 

Example 2): 2 position switch, two speeds.

Select Channel 7

Select the Endpoint Adjust Menu [EPA]

With the switch in the up position, set the EPA to 74%

With the switch in the down position, set the EPA to 42%

AUX1 Switch        Rotor RPM @ 9.3:1

Down                    1200rpm

Up                        1500rpm

 

Example 3): Flight Mode Mixing:

After calibration, move the Auxiliary input to the GYRO channel (Channel 5)

Select the [GYR] menu

Set F-Mode N to 0%

Set F-Mode 1 to 42% (1200rpm @ 9.3:1)

Set F-Mode 2 to 74% (1500rpm @ 9.3:1)

Set F-Mode 3 (Throttle Hold) to 0%

 

Yeilds the following setup:

Flight Mode        Rotor RPM

N                       Disabled

1                        1200rpm

2                       1500rpm

3 (throttle hold) Disabled