The throttle connects to THRO channel (1) The auxiliary connects to AUX2 channel (7) Make sure that any mixing on AUX2 is off. Activate the AUX2 switch in the [17.FUNC.S.] menu. ATV setup [12.TRAVEL] Setup the throttle servo and linkage as close to +/- 100% ATV as possible. Select the AUX2 channel to +100% and -100% Hint: You can observe the AUX2 range on the [75.SERVO.M] screen The system is now ready for calibration. Calibration Procedure For ThrottleMax Calibration, exit at High Stick(Yellow LED)for Limiter mode and Low stick for governor mode(Green LED) The target rotor speed can be calculated using the ATV Calculator Example 1): 2 speed setup: Gear ratio = 9.3:1 ATV- = 39%, ATV+ = 72% AUX2 Sw Posn Rotor RPM (DOWN) 1200 (UP) 1500 Example 2): 1 speed setup and disable: Gear ratio = 9.3:1 ATV- = 0%, ATV+ = 72% GEAR Sw Posn Rotor RPM (DOWN) Disabled (UP) 1500 Example 3): Flight Mode Mixing: Set the throttle curves in Flight modes 1 and 2 above the throttle priority level. Set the AUX2 switch to the down position Set the AUX2 ATV [TRVL ADJ] to -0% Set the AUX2 switch to the up position Set the AUX2 ATV [TRVL ADJ] to +100% Perform the following mix setups with the AUX2 switch in the UP position. [51.PGM.mix1] - This mix disables the Governor in flight mode 'N' AUX2->AUX2 NORM OFFSET 0 -100% (Press the [TURN] to change the sign) +0% [page] NR ACT and S1 ACT and S2 ACT [52.PGM.mix2] - This mix sets the target rpm to 1200rpm (39%) in flight mode '1' AUX2->AUX2 NORM OFFSET 0 +39% +0% [page] S1 ACT only [53.PGM.mix3] - This mix sets the target rpm to 1500 (72%) in flight mode '2' AUX2->AUX2 NORM OFFSET 0 +72% +0% [page] S2 ACT only AUX2 Sw Posn Flight Mode Rotor RPM Down N Disabled 1 Disabled 2 Disabled Up N Disabled 1 1200 rpm 2 1500rpm
The throttle connects to THRO channel (1)
The auxiliary connects to AUX2 channel (7)
Make sure that any mixing on AUX2 is off.
Activate the AUX2 switch in the [17.FUNC.S.] menu.
ATV setup [12.TRAVEL]
Setup the throttle servo and linkage as close to +/- 100% ATV as possible.
Select the AUX2 channel to +100% and -100%
Hint: You can observe the AUX2 range on the [75.SERVO.M] screen
The system is now ready for calibration. Calibration Procedure
For ThrottleMax Calibration, exit at High Stick(Yellow LED)for Limiter mode and Low stick for governor mode(Green LED)
The target rotor speed can be calculated using the ATV Calculator
Example 1): 2 speed setup:
Gear ratio = 9.3:1 ATV- = 39%, ATV+ = 72% AUX2 Sw Posn Rotor RPM (DOWN) 1200 (UP) 1500
Gear ratio = 9.3:1
ATV- = 39%, ATV+ = 72%
AUX2 Sw Posn Rotor RPM
(DOWN) 1200
(UP) 1500
Example 2): 1 speed setup and disable:
Gear ratio = 9.3:1 ATV- = 0%, ATV+ = 72% GEAR Sw Posn Rotor RPM (DOWN) Disabled (UP) 1500
ATV- = 0%, ATV+ = 72%
GEAR Sw Posn Rotor RPM
(DOWN) Disabled
Example 3): Flight Mode Mixing:
Set the throttle curves in Flight modes 1 and 2 above the throttle priority level.
Set the AUX2 switch to the down position Set the AUX2 ATV [TRVL ADJ] to -0% Set the AUX2 switch to the up position Set the AUX2 ATV [TRVL ADJ] to +100% Perform the following mix setups with the AUX2 switch in the UP position. [51.PGM.mix1] - This mix disables the Governor in flight mode 'N' AUX2->AUX2 NORM OFFSET 0 -100% (Press the [TURN] to change the sign) +0% [page] NR ACT and S1 ACT and S2 ACT [52.PGM.mix2] - This mix sets the target rpm to 1200rpm (39%) in flight mode '1' AUX2->AUX2 NORM OFFSET 0 +39% +0% [page] S1 ACT only [53.PGM.mix3] - This mix sets the target rpm to 1500 (72%) in flight mode '2' AUX2->AUX2 NORM OFFSET 0 +72% +0% [page] S2 ACT only
Set the AUX2 switch to the down position
Set the AUX2 ATV [TRVL ADJ] to -0%
Set the AUX2 switch to the up position
Set the AUX2 ATV [TRVL ADJ] to +100%
Perform the following mix setups with the AUX2 switch in the UP position.
[51.PGM.mix1] - This mix disables the Governor in flight mode 'N'
AUX2->AUX2
NORM OFFSET 0 -100% (Press the [TURN] to change the sign) +0%
NORM
OFFSET 0
-100% (Press the [TURN] to change the sign)
+0%
[page]
NR ACT and S1 ACT and S2 ACT
[52.PGM.mix2] - This mix sets the target rpm to 1200rpm (39%) in flight mode '1'
NORM OFFSET 0 +39% +0%
+39%
S1 ACT only
[53.PGM.mix3] - This mix sets the target rpm to 1500 (72%) in flight mode '2'
NORM OFFSET 0 +72% +0%
+72%
S2 ACT only
AUX2 Sw Posn Flight Mode Rotor RPM Down N Disabled 1 Disabled 2 Disabled Up N Disabled 1 1200 rpm 2 1500rpm
AUX2 Sw Posn Flight Mode Rotor RPM
Down N Disabled
1 Disabled
2 Disabled
Up N Disabled
1 1200 rpm
2 1500rpm